HOBO Water Level Data Logger Starter Kit (0 to 9 m)

KIT-S-U20-01

Combining high accuracy water level measurements with out-of-the-box convenience, this money-saving kit includes everything needed to start logging right away. It is ideal for monitoring water levels and temperatures in wells, streams, lakes and freshwater wetlands.

This kit includes:

    U20-001-01 HOBO data logger (0 to 9 m range)
    BASE-U-4 base station with the required coupler
    BHW-PRO HOBOware Pro software.

Like other HOBO Water Level Data Loggers, the 9m version offers exceptional value and ease-of-use, with no cumbersome vent tubes or desiccants to maintain.

Highlighted Features


    Lightning protection - no long signal wires, and electronics are shielded in stainless steel housing
    HOBOware Pro software provides easy conversion to accurate water level reading, fully compensated for barometric pressure, temperature, and water density (use barometric pressure data from nearby weather station).
    Multiple-rate sampling allows faster sampling at critical times such as when pumping starts or stops.
    Available in four depth ranges
    Ideal for use in wells, streams, lakes, wetlands and tidal areas
    No-vent-tube design for easy reliable deployment
    Durable ceramic pressure sensor



The KIT-S-U20-01 kit supports the following measurements: Absolute Pressure, Barometric Pressure, Temperature and Water Level

Pressure Sensor
Operation range: 0 to 207 kPa (0 to 30 psia); approximately 0 to 9 m (0 to 30 ft) of water depth at sea level, or 0 to 12 m (0 to 40 ft) of water at 3,000 m (10,000 ft) of altitude
Factory calibrated range: 69 to 207 kPa (10 to 30 psia), 0° to 40°C (32° to 104°F)
Burst pressure: 310 kPa (45 psia) or 18 m (60 ft) depth
Water level accuracy*: Typical error - 0.05% FS, 0.5 cm (0.015 ft) water
Maximum error: - 0.1% FS, 1.0 cm (0.03 ft) water
Raw pressure accuracy**: 0.3% FS, 0.62 kPa (0.09 psi) maximum error
Resolution: < 0.02 kPa (0.003 psi), 0.21 cm (0.007 ft) water
Pressure response time: 90% < 1 second
Thermal response time (90%)†: Approximately 10 minutes in water to achieve full temperature compensation of the pressure sensor

* With accurate reference water level measurement and Barometric Compensation Assistant data
** Absolute pressure sensor accuracy includes all pressure drift, temperature, and hysteresis-induced errors
† Maximum error due to rapid thermal changes is approximately 0.5%

Temperature Sensor
Operation range: -20° to 50°C (-4° to 122°F)
Accuracy: 0.37°C at 20°C (0.67°F at 68°F), see Plot A
Resolution: 0.1°C at 20°C (0.18°F at 68°F) (10-bit)
Response time (90%): 3.5 minutes in water (typical)
Stability (drift): 0.1°C (0.18°F) per year

Logger
Real-time clock: ± 1 minute per month 0° to 50°C (32° to 122°F)
Battery: 2/3 AA, 3.6 Volt Lithium, factory-replaceable
Battery life (typical use): 5 years with 1 minute or greater logging interval
Memory (non-volatile): 64K bytes memory (approx. 21,700 pressure and temperature samples)
Dimensions: 2.46 cm (0.97 inches) diameter, 15 cm (5.9 inches) length; mounting hole 6.3 mm (0.25 inches) diameter
Weight: Approximately 210 g (7.4 oz)
Wetted materials: 316 stainless steel, Viton® o-rings, acetyl cap, ceramic sensor
Shock/drop: Logger is sensitive to shocks. Handle with care and avoid any impact. Always use proper packaging when shipping the logger.
Logging interval: Fixed-rate or multiple logging intervals, with up to 8 user-defined logging intervals and durations; logging intervals from 1 second to 18 hours. Refer to HOBOware software manual.
Launch modes: Immediate start and delayed start
Offload modes: Offload while logging; stop and offload
Battery indication: Battery voltage can be viewed in status screen and optionally logged in datafile. Low battery indication in datafile.
Environmental Rating: IP68

The CE Marking identifies this product as complying with the relevant directives in the European Union (EU).

You might also like

HOBO Water Level (30 ft)... HOBO Water Level (30 ft)... 2
Product available with different options
Home

HOBO Water Level (30 ft) Data Logger

Onset
U20L-01
The HOBO U20L-01 is a low-cost, research-grade water level data logger for continuously measuring water level and temperature in a wide range of underwater environments. It features 0.1% measurement accuracy, a polypropylene housing for use in both fresh and salt water, and a non-vented design for convenient and hassle-free deployment. This data logger...
View
HOBO Water Level Data... HOBO Water Level Data... 2
Product available with different options
Home

HOBO Water Level Data Logger (0 - 9m)

Onset
U20-001-01
Monitor water levels and temperatures in wells, streams, lakes and wetlands (freshwater) with this 13-foot HOBO Water Level Data Logger. With its narrow range this logger provides the best accuracy in shallow waters. This logger offers a great value and easy deployment since there are no cumbersome vent tubes or desiccants to maintain. For saltwater...
View
HOBO Water Level Data...
Product available with different options
Home

HOBO Water Level Data Logger Starter Kit (0 to 4 m)

Onset
KIT-S-U20-04
Combining high accuracy water level measurements with out-of-the-box convenience, this money-saving kit includes everything needed to start logging right away. It is ideal for monitoring water levels and temperatures in wells, streams, lakes and freshwater wetlands.This kit includes:    U20-001-04 HOBO data logger (0 to 4 m range)    BASE-U-4 base station...
View

Chat with us on WhatsApp

English

English

Do you need advice?
Product added to wishlist
Product added to compare.

We use our own and third party cookies to obtain statistical data from our users' browsing and to improve our services. If you accept or continue browsing, we consider that you accept its use.